Gocator Power/LAN Connector
The Power/LAN connector is a 14 pin, M16 style connector that provides power input, laser safety input, and Ethernet.
|
This connector is rated IP67 only when a cable is connected or when a protective cap is used. |
|
|
Some sensors require a minimum input voltage of 48 VDC. Verify the accepted input voltage for your sensor in the sensor's specifications; for specifications, see Sensors. |
This section defines the electrical specifications for Power/LAN Connector pins found on G1, G2, and G3 sensors, organized by function.
|
Function |
Pin |
Lead Color on Standard Cordsets |
Lead Color on High Flex Cordsets |
|
|---|---|---|---|---|
|
GND_24-48V* |
L |
White/Orange & Black |
Orange/Red |
View: Looking into the connector on the sensor |
|
GND_24-48V* |
L |
Orange/Black |
Orange/Black |
|
|
DC_24-48V* |
A |
White/Green & Black |
Green/Red |
|
|
DC_24-48V* |
A |
Green/Black |
Green/Black |
|
|
Safety- |
G |
White/Blue & Black |
Blue/Black |
|
|
Safety+ |
J |
Blue/Black |
Blue/Red |
|
|
Sync+** |
E |
White/Brown & Black |
Brown/Red |
|
|
Sync-** |
C |
Brown/Black |
Brown/Black |
|
|
Ethernet MX1+ |
M |
White/Orange |
White/Orange |
|
|
Ethernet MX1- |
N |
Orange |
Orange |
|
|
Ethernet MX2+ |
O |
White/Green |
White/Green |
|
|
Ethernet MX2- |
P |
Green |
Green |
|
|
Ethernet MX3- |
S |
White/Blue |
White/Blue |
|
|
Ethernet MX3+ |
R |
Blue |
Blue |
|
|
Ethernet MX4+ |
T |
White/Brown |
White/Brown |
|
| Ethernet MX4- | U | Brown | Brown |
*Both wires must be connected to the power supply. The leads are connected to the same connector pin, and both are required to support the maximum possible current draw.
**The Sync leads are not connected in the open wire versions of the Power/LAN cordsets.