Gocator Power/LAN Connector
The Gocator Power/LAN connector is a 16-pin, M16 style connector that provides power input, sync, and Ethernet.
|
This connector is rated IP67 only when a cable is connected or when a protective cap is used. |
|
|
G5 sensors require a minimum input voltage of 24 VDC. Verify the accepted input voltage for your sensor in the sensor's specifications; for specifications, see Sensors. |
This section defines the electrical specifications for Power/LAN Connector pins found on G5 sensors, organized by function.
*Both wires must be connected to the power supply. The leads are connected to the same connector pin, and both are required to support the maximum possible current draw.
**The Sync leads are not connected in the open wire versions of the Power/LAN cordsets.
|
Function |
Pin |
Lead Color on Cordsets |
|
|---|---|---|---|
|
24-48V (MAIN)* |
L |
Grey/Red |
View: Looking into the connector on the sensor |
|
GND_24-48V (MAIN)** |
M |
Grey/Black |
|
|
24-48V (MAIN)* |
L |
Pink/Red |
|
|
GND_24-48V (MAIN)** |
M |
Pink/Black |
|
|
24-48V (AUX)* |
A |
Red |
|
|
GND_24-48V (AUX)** |
N |
Black |
|
|
24-48V (AUX)* |
A |
Orange/Red |
|
|
GND_24-48V (AUX)** |
N |
Orange/Black |
|
|
24-48V (AUX)* |
B |
Yellow/Red |
|
|
GND_24-48V (AUX)** |
C |
Yellow/Black |
|
|
- |
O |
- |
|
|
- |
D |
- |
|
|
Ethernet MX1+ |
E |
Violet/Red |
|
|
Ethernet MX1- |
F |
Violet/Black |
|
|
Ethernet MX2+ |
G |
Green/Red |
|
|
Ethernet MX2- |
H |
Green/Black |
|
|
Ethernet MX3- |
R |
Blue/Red |
|
|
Ethernet MX3+ |
P |
Blue/Black |
|
|
Ethernet MX4+ |
I |
Brown/Red |
|
| Ethernet MX4- | K | Brown/Black |
*All 24-48V wires (MAIN and AUX) are soldered together.
**All GND_24-48V (MAIN and AUX) wires are soldered together.