Installing DIN Rail Clips: Master 810 or 2410

You can mount the Master 810 and 2410 using the included DIN rail mounting clips with M4x8 flat socket cap screws. The following DIN rail clips (DINM12-RC) are included:

Older revisions of Master 810 and 2410 network controllers use a different configuration for the DIN rail clip holes.

To install the DIN rail clips:

1.

Remove the 1U rack mount brackets.

2.

Locate the DIN rail mounting holes on the back of the Master (see below).

Master 810:

Current revision

Older revision

Master 2410:

 

Current revision

Older revision

3.

Attach the two DIN rail mount clips to the back of the Master using two M4x8 flat socket cap screws for each one.

The following illustration shows the installation of clips on a Master 810 (current revision) for horizontal mounting:

Ensure that there is enough clearance around the Master for cabling.